AMX NXD/NXT-1700VG, NXD/NXT-1500VG manual Installing the NXD into a Flat Surface using #4 screws

	Installation Procedures: 12" and 15" Panels
		4 notches are
		required if the
Install the four drywall		unit is installed in
		drywall using the
clip sets (included)
		four (4) provided
into these holes
		drywall expansion
		clips

Mounting Tab

A - Faceplate

B - Main NXD unit consists of the touch panel and housing

(bezel)

FIG. 42 Wall Mount panel (NXD) installation configuration for drywall surfaces

The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed during a re-installation.

11.Place the magnetic faceplate (A in FIG. 42) back onto the main NXD unit (B in FIG. 42). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

12.Connect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.

13.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

Installing the NXD into a Flat Surface using #4 screws

Mounting screws (#4, not included) are secured through circular holes located at the left and right sides of the NXD panel. The most important thing to remember when mounting the NXD is that the

outer frame (Mounting Tabs) must be installed flush against the mounting surface.

It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

1.Prepare the area by removing any screws or nails from the surface before beginning the cutout process.

2.Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 43 and for the 15-inch Wall Mount using the dimensions shown in FIG. 44.

VG-Series Modero Touch Panels 63