AMX NXD/NXT-1200VG, NXD/NXT-1500VG, NXD/NXT-1700VG manual 178

Displaying Stream Content

Incoming Video signal

Once done making your screen adjustments, SAVE SETTINGS.

FIG. 136 Video Adjustment page (showing default values)

If there is no signal displayed, return to the MAX-CSE UI pages and from the Encoder Profiles page, confirm that the correct panel IP Address and target port where entered into the Streaming Source field within the TPDesign4 project.

If this still doesn’t produce a displayed signal, cycle the Play/Stop buttons and verify that both the encoding Status says Streaming (verifying that the process of encoding is underway) and that the unit is detecting an incoming signal (shown by the word SYNC appearing in the Video Sync section of the UI).

The most common error can result from a bad cable not being detected and therefore no signal becomes available for the unit to encode. The encoding process can continue on a MAX-CSE even without an actual signal being detected.

178 VG-Series Modero Touch Panels