AMX NXD/NXT-1500VG, NXD/NXT-1700VG, NXD/NXT-1200VG manual Close and Resecure the NXT Panel Enclosure

Touch Panel Accessories

Card removal grooves

On-board Compact

Flash connector (with pins)

Insert with arrow facing towards the pins

Connector opening

FIG. 21 Removing/installing a Compact Flash Memory card

4.Remove the new CF memory card from it’s anti-static bag.

5.Grip the sides of the new CF memory card and firmly insert it into the slot opening (with the arrow facing towards the pins) until the contact pins are completely inside the flash card and it is then securely attached to the pin sockets.

6.To complete the upgrade process, close and resecure the panel enclosure using the procedures in the following step.

Any new internal component upgrade is detected by the panel only after power is cycled.

Step 5: Close and Resecure the NXT Panel Enclosure

1.Obtain the new RGB I/O connector plate (similar to the original but containing the added RGB connector opening to the newly installed NXA-RGB) and slide it back into position.

2.Resecure the Stereo Output nut back onto the new Stereo Output jack onto the new RGB I/O plate.

3.With the components securely installed, tilt the LCD back to a 45° and then gently slide-on the outer housing (towards the LCD) until the it is aligned over the installation holes and the tilt bracket prevents any further forward movement (FIG. 19).

4.Gently press down on the housing (toward the base) until it is securely positioned over the circuit board and cover base.

Use caution when re-installing the outer housing. Improper re-installation can cause damage to the internal speakers.

5.While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown on a soft cloth and the under-side of the base is exposed.

6.Insert and secure the eight Housing Screws (using a grounded Phillips-head screwdriver) into their respective locations (FIG. 15).

7.Replace any adhesive plastic "feet" that might have been removed during the removal process of the outer housing. These "feet" must be placed back onto their original locations so they can fit into their provided openings on the Battery Base.

VG-Series Modero Touch Panels 41