AMX NXD/NXT-1500VG manual VG-Series Modero Connectors, Connecting and Using USB Input Devices

Introduction

1700VG Panel Specifications (Cont.)

Other AMX Equipment (Cont.):

• Upgrade Compact Flash (factory programmed with firmware): NXA-CFTPV256M- 256 MB V/VG compact flash card (FG2116-43) NXA-CFTPV512M- 512 MB V/VG compact flash card (FG2116-44) NXA-CFTPV1G- 1 GB V/VG compact flash card (FG2116-45)

VG-Series Modero Connectors

FIG. 1 shows the connectors on the VG-Series Modero panels.

NXT VG-Series connectors located on

rear panel of the base RGB

AL

NXD VG-Series connectors located on left side panel

			12VDC
RGB	AUDIO/VIDEO	ETHERNET	PWR

PROGRAM

				Stereo	Keyboard/Mouse
			Power	Output
Composite/RGB	Audio-Video from				USB connectors (2)	Mini-USB
		Ethernet
and pass-thru	NXA-AVB/RGB					(Program Port)
control (CAT5)	(CAT5)	(CAT5)

FIG. 1 Connector layout on sample VG-Series Video Touch Panels (RGB connector available with RGB Kit)

Connecting and Using USB Input Devices

These panels can have up to two USB-capable input devices connected for use both on its different firmware and TPD4 panel pages. These input devices can consist of a keyboard or mouse.

USB-connected input devices are detected and recognized by the panel upon connection. Refer to the Configuring and Using USB with a Virtual Master section on page 95 for more information on using a USB connection.

1.Insert the input device USB connectors into the appropriate USB connector on the panel.

2.Press the on-screen Reboot button (Protected Setup page) to save any changes and restart the panel.

3.After the panel splash-screen disappears:

If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location corresponds to the mouse cursor position sent by the external USB mouse.

If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any external keystrokes sent from the external USB keyboard.

VG-Series Modero Touch Panels 17