Firmware Pages and Descriptions
161
VG-Series Modero Touch Panels

The elements of the Password Setup page are described in the table below:

Calibration Page

This page (FIG.124) allows you to calibrate the input touch device (touch panel) using the pre-selected

touch driver.

Press and hold the grey Front Setup Access button (below the Modero LCD) for 6 seconds to

access the Calibration page.

Press the crosshairs to calibrate the panel and return to the last active firmware page.

Password Setup Page Elements

Back: Saves the changes and returns you to the previously active touch panel page.
Connection Status icon: This visual display of the connection status allows the user to have a current
visual update of the panel’s connection status regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection
with a currently secured target Master (requiring a username and password).
In Panel Password
Change:
Accesses the alphanumeric values associated to particular password sets.
• PASSWORD 1, 2, 3, 4, 5 (protected) buttons open a keyboard where you can
enter alphanumeric values associated to a selected password group.
• Clearing Password #5 removes the need to enter a password before
accessing the Protected Setup page.
FIG. 124 Calibration page (actually 3 separate screens)
The request to touch the crosshairs
is the first on-screen message
Calibration successful is the second
on-screen message that appears
On-screen crosshairs used for
calibration of the touch device
after the calibration process is
completed

If the calibration was improperly set and you cannot return to the Calibration

page (through the panel’s firmware); you can access this firmware page via

G4 WebControl where you can navigate to the Protected Setup page and press the

Calibrate button through your VNC window.

This action causes the panel to go to the Calibration page seen above, where you

can physically recalibrate the actual touch panel again using the above procedures.