AMX NXD/NXT-1700VG manual Installation and Upgrade of the Internal NXD Components, Do not Remove

Touch Panel Accessories

8.Grasp both the LCD and housing and then rotate the entire unit back onto a flat surface.

9.Insert all connectors and apply power.

Installation and Upgrade of the Internal NXD Components

Upgrading the components within a WallMount panel involves removing the rear plastic outer housing (back box), removing and/or installing an existing component, and then placing the back box back onto the NXD panel, as described in the following sections.

Step 1: Remove the existing NXD Outer Housing

1.Carefully detach all connectors from the side of the touch panel and remove the front magnetic faceplate from the NXD unit by firmly gripping the faceplate and pulling outwards, while applying a small amount of pressure to remove it from the main unit.

2.Place the LCD facedown onto a soft cloth to expose the under-side of the unit. This step helps prevent scratching of the LCD.

3.Unscrew the Stereo Output nut from the Stereo Output jack.

4.Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide the I/O connector plate away from the back box housing.

DO NOT REMOVE THE PANEL SECURING SCREWS. These screws secure the

LCD to the metallic casing.

5.Unscrew the four pan-head Housing Screws from the rear of the NXD unit (FIG. 22) and gently remove the outer housing. These four screws secure the back box to the internal panel casing.

DO NOT
REMOVE	DO NOT REMOVE
these
	these panel
panel
	securing screws
securing
screws

Unscrew these four Housing Screws to remove the back box.

These make direct contact with the black outer housing.

FIG. 22 Location of the securing screws on an NXD panel

42 VG-Series Modero Touch Panels