Four notches are

 

required if the

 

unit is installed in

 

drywall using the

Install the four

four provided

drywall expansion

drywall clip

clips

sets (included) into

 

these holes

 

Mounting

 

Tab

 

A - Faceplate (bezel)

Installation Procedures: 17" Panels

13.554" (34.43 cm)

Notching of one or more stud beams may be required if the unit is not framed into the wall.

B - Main NXD unit consists of

the LCD panel and back box housing

FIG. 60 Wall Mount panel (NXD) installation using expansion clips

7.Carefully lay the separated LCD (from the main unit) onto a soft cloth resting on a level surface to prevent scratching of the LCD.

8.Insert the back box into the cutout to check for fit. Make any adjustments to the dimension of the cutout to accommodate the back box.

9.Cutout the notched beam (FIG. 59) using a height of 13.554" (34.43 cm) and a depth using the following guideline. This notched beam is located on the side of the NXD unit furthest away from the connectors.

Calculate the distance from the edge of the mounting ridge (FIG. 59) to the rear point (on the box) where the beam touches the back box.

Our example uses 1 3/8" (inches) (on the deepest point of the rear back box).

Calculate the thickness of the drywall/sheetrock. Our example uses 5/8" (inches).

The depth of the notch: 1 3/8" minus 5/8" = 6/8" (inches). This value reflects the cutout depth necessary for the mounting ridge on the back box to be flush against the surface.

The determining factor in the depth of the cut into the beam is the thickness of the drywall. The MOUNTING TAB MUST BE FLUSH against the drywall and therefore, the depth of the notch depends on that thickness.

10.Thread the incoming RJ-45, Ethernet, and any other audio/video wiring (from their terminal locations) through the cutout opening. Refer to the Wiring Guidelines for the 1700VG Panels section on page 87 for pinout descriptions. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

VG-Series Modero Touch Panels

81

 

 

Page 91
Image 91
AMX NXD/NXT-1700VG, NXD/NXT-1500VG, NXD/NXT-1200VG manual Four notches are