Introduction
14 VG-Series Modero Touch Panels
1700VG Panel Specifications (Cont.)
Front Panel Components:
Light sensor: • Photosensitive light detector for automatic adjustment of the panel
brightness (a dim room results in a dimmer LCD display and a bright
room results in a brighter LCD display).
Note: The light sensor can be adjusted via the Sensor Setup Pagesection
on page158.
Motion sensor (PIR): • Proximity Infrared Detector to wake the panel when the panel is
approached.
• Activation range: + 20° vertically from center and + 45° horizontally
from center.
Note: The motion sensor can be adjusted via the Sensor Setup
Pagesection on page 158.
Front setup access button: • Provides both access to the Setup and Calibration pages and toggles the
panel between a "sleep" and "wake" state.
- When wired, "sleep" status means the backlight is Off.
- When battery operated, wireless "sleep" status means the touch panel
base is either Off or "suspended".
Microphone: • Used for intercom applications (requires an optional NXA-AVB/RGB or
NXA-AVB/ETHERNET Breakout Box).
Speakers: • Stereo output with a frequency response of 450 Hz - 7 KHz
Rear Panel Components: (Side panel location on NXD-Wall Mount panels)
RGB connector • This connector is only made available only by using an NXA-RGB
interface card installed within the touch panel. This card is sold either as
part of an RGB Kit configuration or within the NXA-RGBKIT upgrade kit
for previous Video Kit fitted VG-Series panels.
• Routes RGB and computer control pass-thru signals to/from a Modero
panel up to 200 ft. (60.9 m).
• RJ-45 connector provides RGB/Component video signals (being routed
from the rear RGB/Component input ports) and touch control information
to the RJ-45 RGB connector on the NXA-RGB card (installed within the
panel). This connector routes VGA and Component video signals.
Audio/Video connector: • RJ-45 connector for communication of differential audio/video signals
to/from the touch panel (panel type dependant). This connector receives
Composite video, Stereo (left/right) audio, and microphone audio.
• Video is received via the NXA-AVB/RGB Breakout Box. Configuring
video windows for playback is done using TPDesign4.
• In-bound audio (from the Breakout Box) gets directed to the speakers.
• Out-bound audio is sent from the on-board microphone (on the
front-panel). Selecting audio files for playback is configured through
TPDesign4.
Ethernet 10/100 port: •RJ-45 port for 10/100 Mbps communication. The Ethernet port
automatically negotiates the connection speed (10 Mbps or 100 Mbps),
and whether to use half duplex or full duplex mode.
• These panels communicate with the NetLinx Master using the ICSP
protocol over Ethernet.
PWR connector: • 2-pin 3.5 mm mini-Phoenix connector.
Stereo Output connector: • Stereo output through a 3.5mm mini-jack (for use with external
speakers).
Ethernet 10/100 LEDs: • LEDs show communication activity and connection information:
A-activity - Yellow LED lights when receiving or transmitting Ethernet
data packets.
L-link - Green LED lights when the Ethernet cables are connected and
terminated correctly.