AMX NXD/NXT-1200VG, NXD/NXT-1500VG, NXD/NXT-1700VG manual Checking the NXT-BP battery charge

Touch Panel Accessories

Checking the NXT-BP battery charge

1.Press the Battery Life Indicator button (FIG. 27) once to illuminate the Battery Life LEDs and display the percent charge remaining on the battery (this indication lasts a few seconds).

Battery Life (Charge) Display

Battery Life Indicator button

FIG. 27 NXT-BP (showing Battery Life Indicator button and charge)

2.Repeat the above step for each NXT-BP battery.

3.Charge the NXT-BP battery by either inserting it into the battery base or from within the optional NXT-CHG charger (which can sequentially charge up to two batteries).

If the 25% LED is blinking, this indicates there is less than 5% of a charge remaining on the battery.

Installing the NXA-BASE/B to an NXT Modero Panel

The battery base must be installed onto the NXT panel without any NXT-BP batteries.

1.Power Off the panel before attempting to use the NXA-BASE/B.

2.Place the empty battery base onto a flat/level surface.

3.Verify the alignment of the Panel Interface connectors between the panel (male connector) and base (female connector) (FIG. 28).

Battery Compartment	Captive fasteners
pulls outwards	(secure base to
	panel)

Panel Interface connector (female)

Alignment pegs

FIG. 28 NXA-BASE/B showing Panel Interface and connector locations

4.Carefully place the Modero panel over the base alignment pegs (FIG. 28 and FIG. 29).

46 VG-Series Modero Touch Panels