AMX NXD/NXT-1500VG, NXD/NXT-1700VG manual Unpacking the Panel, Installing Internal Components

Installation Procedures: 12" and 15" Panels

Installation Procedures: 12" and 15" Panels

Overview

NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-BASE/B battery base) configuration. NXD panels are installed into either a pre-wall surface (using a CB-TP12/CB-TP15 conduit/wallbox) or a solid surface (using either solid surface or drywall screws).

It is recommended that if you are planning on upgrading your panel components (flash, wireless, RGB card), you do so before beginning any panel installations.

Unpacking the Panel

1.Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to the Specifications sections on page 2 and page 7 for more information about included accessories and other AMX equipment.

2.Carefully remove the panel from the shipping box.

3.Carefully peel the protective plastic cover from the LCD.

If the protective plastic LCD cover is not removed, the panel may not respond properly to touch points on the LCD or allow proper screen calibration.

Installing Internal Components

Installation of the internal components such as the NXA-PCI80211G Wireless card and NXA-RGB Interface card are described in detail within the following sections:

Step 2: Install the 802.11g mini-PCI Wireless Card section on page 38.

Step 3: Install the NXA-RGB Card Component (NXT) section on page 39.

Upgrading to the MB-TP12/MB-TP15 VESA Mounting Kit

Upgrading the existing back box with the new VESA Mounting Kit on both the 12" (FG031-50) and 15" panel (FG032-50) is identical and requires 3 main processes:

Removing the pre-existing back box and installing the new VESA back box.

Threading cables through the strain relief grommet opening in the rear plastic cover.

Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover, securing both components, and finalizing the strain relief grommet installation.

The installation procedures found in this section are identical for both sizes of panels (12" and 15"). Only overall dimensions and FG product numbers are different.

The new MB-TP Universal VESA Mounting Box uses a standard VESA installation pattern of 75 mm between holes. VESA mounts that conform to this pattern can be used on the MB-TP Housing.

VG-Series Modero Touch Panels 53