AMX NXD/NXT-1200VG Cable Installation for the MP-TP12/15 Back Box, Finalizing the installation

Installation Procedures: 12" and 15" Panels

DO NOT REMOVE

Twelve

#6-32 securing

screws

MB-TP12/15 back box

Connector Opening

Strain relief grommet (Clip facing up) Rim of the strain relief grommet should lie flush against enclosure

Securing hole locations (3 on each side)

Internal panel casing

Four (pan-head) Housing Screws

Rear plastic cover

Four (#8-32) screws

FIG. 34 Location of the attachment screws on the NXD back box and VESA housing

Cable Installation for the MP-TP12/15 Back Box

1.Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective locations along the side of the touch panel.

2.Use the tie-wrap (45-0009A) to wrap the cables together inside the VESA Mount enclosure. This cable tie is used to insure the cable will not pull through or work itself through the new larger strain relief grommet (45-0032-01) over time.

3.Thread the incoming cables through the hole on the rear plastic cover and then through the strain relief grommet.

4.Slide the grommet along the cable and securely insert it into the opening on the rear plastic cover (FIG. 34).

Finalizing the installation

1.Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP12/15 back box).

2.Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open strain relief grommet.

3.Allow some slack/length on these cables as a service loop. This service loop provides enough cable length so you can later remove the NXD (with connected cables) from the rear plastic cover.

VG-Series Modero Touch Panels 55