AMX NXD/NXT-1200VG manual Using the HD-15 high-density connector, Installing the NXA-AVB/RGB

Touch Panel Accessories

Using the HD-15 high-density connector

Connect the RGB/Comp source equipment HD-15 (male) connector to the RGB/COMPONENT HD-15 high-density connector (female) on the rear of the NXA-AVB/RGB Breakout Box. The following table below lists the HD-15 connector pinouts.

HD-15 Connector Pinouts

Pin	Signal	Function
1	Red	Red signals/Cr
2	Green	Green signals/Y
3	Blue	Blue signals/Cb
4	N/A	Not used
5	GND	Signal Ground	5
6	RAGND	Red analog ground
7	GAGND	Green analog ground
8	BAGND	Blue analog ground
9	N/A	Not used	1
10	SAGND	Synchronization analog ground
11	N/A	Not used
12	N/A	Not used
13	HSYNC	Horizontal synchronization signal
14	VSYNC	Vertical synchronization signal
15	N/A	Not used

10

6

HD-15 (male) connector

15

11

Installing the NXA-AVB/RGB

A 12 VDC-compliant power supply can indirectly provide power to a Modero panel by routing power through the NXA-AVB/RGB Breakout Box. FIG. 3 shows a sample wiring configuration using both an indirect or direct power connection for a VG-Series Modero panel.

12 VDC power

supply

Indirect

Connect

Power supplied via Breakout Box

12 VDC power

supply

Direct

					Audio In Mic Out					Line Level out
		Ethernet			(6-pin) (4-pin)					(to amplifier
		(RJ-45)					USB			or VOL card)
Video In							(pass-thru)
	(BNC)								RGB In (HD-15)
											(rear)
				NXA-AVB/RGB
				Breakout Box
											(front)
			Ethernet			Audio/Video		RGB (RGB and touch
				(CAT5)		(CAT5)		control) (CAT5)

or

Connect

VG-Series and Video-capable

Touch Panels

FIG. 3 Sample Wiring configuration using the NXA-AVB/RGB Breakout Box

22 VG-Series Modero Touch Panels