AMX NXD/NXT-1200VG, NXD/NXT-1500VG manual Replacement drywall clip sets must be ordered from AMX

Installation Procedures: 17" Panels

11.Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify the terminal end of the power cable is not connected to a power supply before plugging in the 2-pin power connector.

The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

12.Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify the panel is receiving power and functioning properly to prevent repetition of the installation.

13.Disconnect the terminal end of the power cable from the connected power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the drywall.

14.Follow the procedures outlined within Steps 1 - 5 on page 42 thru page 43 to carefully reinstall the LCD panel back into the back box housing.

15.Install the four sets of drywall screws and expansion clips into the four oval notch locations along the top/bottom edges of the main unit (FIG. 60). Make sure the top drywall clip grooves face upwards and the bottom clip grooves face downwards (so they extend away from the Main unit).

16.Carefully insert the main unit (with expansion clips) into the cutout until the Mounting Tabs on the NXD unit lie flush against the wall (FIG. 60). Make sure to have the right side of the box resting against the non-notched beam (on the right) and the connector-side of the unit pressed into the notched beam (on the left).

Replacement drywall clip sets must be ordered from AMX.

17.Tighten the drywall clip sets (screws and clips) until the Mounting Tabs are securely fastened and flush against the wall.

18.Place the magnetic faceplate (A in FIG. 60) back onto the main NXD unit. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

19.Reconnect the terminal RJ-45, Ethernet, and any optional audio/video wiring to their respective terminal locations on either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.

20.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

82 VG-Series Modero Touch Panels