AMX NXD/NXT-1700VG, NXD/NXT-1500VG Connection Status, Display/Panel Timeout, Inactivity Page Flip

	Firmware Pages and Descriptions
Setup Page Elements (Cont.)
Connection Status:	Displays whether the panel is communicating externally, the encryption status
	of the communicating Master, what connection type is being used (Ethernet or
	USB), and what System the panel is a part of.
	This visual display of the connection status is also reflected at the upper-right of
	each firmware page. This allows the user to have a current visual update of the
	panel’s connection status regardless of what page is currently active.
	• When a connection is established, the message displayed is either:
	"Connected via Ethernet " or "Connected via USB ".
	• If no connection can be established by the Modero panel, it will continue to try
	and establish a connection while displaying: "Attempting via ...".
	• The word "Encrypted" appears only when an encrypted connection is
	established with a target Master.
	• The panel must be rebooted before incorporating any panel communication
	changes and detecting any active Ethernet connections.
	The Ethernet connection is not detected until after a reboot.
Display/Panel Timeout:	Sets the length of time the panel can remain idle before activating the sleep
	mode. When the device goes into sleep mode, the LCD is powered-down.
	• Press the UP/DN buttons to increase/decrease the time until the panel
	times out. Range = 0 - 240 minutes.
	• Use this button to set the timeout value to zero and disable the sleep mode.
	• Note: Display timeout values affect battery performance. Small timeout values
	increase the life of the battery charge. Greater timeout values may require
	more frequent battery charging.
Inactivity Page Flip	Sets the number of minutes of inactivity before the panel automatically flips to a
Timeout:	pre-selected touch panel page. When the device goes into this inactivity mode,
	the LCD does not power-down.
	• Press the UP/DN buttons to increase/decrease the time the panel can remain
	inactive before it flips to the preset page. Range = 0 - 240 minutes.
	• Use this button to set the timeout value to zero and disable the inactivity page
	flip mode.
	• The touch panel page used for the Inactivity page flip is shown within a small
	Inactivity Page field.
Panel Brightness:	Sets the display brightness level of the panel.
	• Press the UP/DN buttons to adjust the brightness level. Range = 0 - 100.
	• The on-screen bargraph can be dragged to adjust the Brightness level which
	is then reflected as a corresponding numeric value within the Panel
	Brightness field.

VG-Series Modero Touch Panels 135