AMX NXD/NXT-1500VG, NXD/NXT-1700VG, NXD/NXT-1200VG manual Connectors Left Side

Installation Procedures: 17" Panels

INSTALLER: LEAVE A GAP BETWEEN THE SURFACE OF THE STUD AND THE

BACK BOX MOUNTING RIDGE TO ACCOMMODATE THE DRYWALL/

SHEETROCK. This gap allows the installation of the drywall/sheetrock after the back box has been mounted onto the beams.

2.Locate the edges of the two studs used in this installation. The location of the NXD is site dependant and could involve notching more than one beam.

In this sample installation, the left beam is notched and the back box rests against the right beam.

3.Remove any screws/nails from the drywall, along the notched beam, before beginning the cutout process.

4.Cut out the surface for the NXD-1700VG Wall Mount using the dimensions shown in FIG. 59.

Be sure to cut out the four notches along the top and bottom areas to accommodate the four drywall expansion clips (provided).

* *

* Top notches are not symmetrical

Connectors

Left Side Right Side

FIG. 59 NXD-1700VG Wall Mount panel dimensions using expansion clips

5.Remove the magnetic faceplate/bezel (A in FIG. 60) from the main NXD unit (B in FIG. 60) by gripping the faceplate and pulling with gentle outward force.

6.Follow the procedures outlined within Steps 1 - 5 on page 42 thru page 43 to carefully reinstall the LCD panel back into the back box housing.

80 VG-Series Modero Touch Panels