AMX NXD/NXT-1700VG, NXD/NXT-1500VG, NXD/NXT-1200VG manual Screws not included

Installation Procedures: 12" and 15" Panels
Attachment is done	Flat surface
along the edges of	(can include a
the cutout	wall, podium, or
Install the four (#4)	other flat
mounting screws	surface)
into the holes
(screws not included)

A - Faceplate	B - Main NXD unit consists of
(bezel)	the touch panel and housing

FIG. 45 Wall Mount panel installation configuration for flat/solid surfaces

11.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.

12.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

Installing an NXD into an (optional) Rack Mount Kit (NXA-RK12 or NXA-RK15)

1.Remove the magnetic faceplate/bezel from the main NXD unit by gripping the faceplate and pulling with gentle outward force.

2.Thread the incoming RJ-45, Ethernet, USB, and any optional audio/video wiring through the opening in the equipment rack (from their terminal locations). Refer to the Wiring Guidelines for the 1200VG and 1500VG Panels section on page 68 for pinout descriptions. Leave enough slack to accommodate any re-positioning of the panel.

3.Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify the terminal end of the power cable is not connected to a power supply before plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

4.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify the panel is receiving power and functioning properly to prevent repetition of the installation.

5.Disconnect the terminal end of the power cable from the connected power supply.

66 VG-Series Modero Touch Panels