AMX NXD/NXT-1700VG, NXD/NXT-1500VG, NXD/NXT-1200VG Wiring for Pass-Thru Computer Control, N E L

Touch Panel Accessories

Wiring for Pass-Thru Computer Control

1.Discharge any acquired static electricity by touching a grounded metal object.

2.Turn-off your computer and remove any installed power cables. Review FIG. 7 for an overview of the overall wiring configuration surrounding pass-thru control.

PC	RGB/Component In
		(HD-15)

USB

(Type-A)

	USB
	(Type-B)
12 VDC power
supply	Ethernet	R
	(RJ-45)	E
		A
		R

FIG. 7 Pass-thru control wiring configuration

	F
	R
	O
	N
	T
Breakout Box	NXA-AVB/RGB
			RGB
		(CAT5)
			Ethernet
		Out (CAT5)
			Power to
			touch panel

P A N E L

3.Use an HD-15 video cable to create a connection between the computer’s video output connector and the HD-15 D-Sub RGB/VGA/Component connector on the rear of the NXA-AVB/RGB.

This HD-15 D-Sub RGB/VGA/Component connector on the breakout box is used to route an RGB (computer) or Component (DVD/HDTV) signal to a target Modero panel (using the internal NXA-RGB card).

4.Use a Type-A to Type-B USB cable to create a connection from USB connector on the computer to the rear Type-B USB device port input connector on the rear of the NXA-AVB/RGB.

This connection routes pass-thru computer control from the touch panel, to the front RGB RJ-45 connector, and then through the rear USB port to the PC. Touch information is sent to and from the panel via this two-way connector.

5.Verify the panel has been configured to communicate by connecting an RJ-45 10/100baseT Ethernet connector from the rear Ethernet port on the breakout box to a valid Ethernet Hub.

6.Connect the incoming power connector to the 12 VDC power connector on the rear of the box.

DO NOT CONNECT POWER UNTIL THE UNIT IS COMPLETELY INSTALLED.

7.Use the NXA-MTC/RGB to create a connection between the NXA-AVB/RGB and the target VG-Series touch panel. Refer to the following NXA-MTC/RGB Combo Table Top Cable (CA2250- 70) section on page 28 for more detailed cable information.

8.Connect a USB mouse/keyboard to the available connectors on the target touch panel.

9.Verify a proper installation of all of the RJ-45 and power connectors between the target touch panel and breakout box.

10.Verify a proper installation of all of the RJ-45, HD-15, and power connectors between the rear of the breakout box and the computer.

11.Provide power to both the computer and the NXA-AVB/RGB Breakout Box.

VG-Series Modero Touch Panels 27