AMX NXD/NXT-1700VG, NXD/NXT-1500VG, NXD/NXT-1200VG manual Panel Calibration

	Table of Contents
Ethernet/RJ-45 Port: Connections and Wiring	69
Installation Procedures: 17" Panels	71
Overview	71
Unpacking the Panel	71
Installing the Internal Components	71
Upgrading the Back Box with the MB-TP17 VESA Housing	71
Removing the Original Modero Back Box	71
Installing the MP-TP17 Back Box	72
Cable Installation for the MP-TP17 Back Box	73
Finalizing the installation	73
Pre-wall Installation of the CB-TP17 Conduit Box	75
Installation of an NXD-1700VG	77
Installing the NXD-1700VG within a CB-TP17 Conduit Box	77
Installing the NXD-1700VG into drywall using Expansion Clips	79
Installing the NXD-1700VG into a Flat Surface using #6 screws	83
Installing an NXD into an (optional) Rack Mount Kit (NXA-RK17)	86
Wiring Guidelines for the 1700VG Panels	87
Preparing captive wires	87
Wiring a power connection	87
Audio/Video Port: Connections and Wiring	88
Ethernet/RJ-45 Port: Connections and Wiring	88
Panel Calibration	91
Overview	91
Calibrating the Modero Panel	91
Testing your Calibration	92
Configuring Communication	93
Overview	93
Modero Setup and System Connection	93
Configuring and Using USB with a Virtual Master	95
Step 1: Setting up the USB Driver on the PC	95
Step 2: Confirming the Installation of the USB Driver on the PC	96
Step 3: Confirm and View the current AMX USB device connections	98
Step 4: Using a USB to Configure a Virtual Master (using NetLinx Studio)	98
Step 5: Confirm and View the current AMX USB device connections	100
Wireless Settings Page - Wireless Access Overview	101
IP Routing	101
Hot Swapping	101
Configuring a Wireless Connection	102
Step 1: Configuring the Panel’s Wireless IP Settings	102

VG-Series Modero Touch Panels iii