AMX NXD/NXT-1500VG BOB Version, Cable Variance, Short, Medium, and Long, RGB Input Resolution

	Firmware Pages and Descriptions
RGB Adjustment Page Elements (Cont.)
Settings:	• The Default Settings button sets the RGB settings to their default values
	(indicated in this table).
	• The Undo Changes button disregards any changes made on the page since
	the last settings were saved.
	• The Save Settings button saves any changes made to the RGB Adjustment
	page.
	• The Sync on Green button sets the NXA-RGB card to search for the sync
	signal on Green signal.
Version:	Displays the firmware version being used by the internal NXA-RGB card.
BOB Version:	Displays the firmware version of the communicating NXA-AVB/RGB Breakout
	Box.
	• If firmware is updated to either the panel or the breakout box, both units must
	be power-cycled for the panel to detect and display the BOB firmware
	version.
Status:	Displays the input signal properties of the signal routed through the internal
	NXA-RGB card (H-pixel x V-pixel @ Hz). An example is: 1024x768@85Hz.
Cable Variance:	Allows you cycle through a choice of available cable compensation parameters
	(Short, Medium, and Long).
	• This field adjusts the cable compensation for any signal degradation over a
	selected cable length.
	• This adjustment is done by using preset calculations to take into account the
	length and type of cable being used to transmit the signal.
	• Toggling the field can correct some signal problems.
RGB Input Resolution:	Use the UP/DN buttons to alter the input resolution of the RGB signal being
	routed through the internal NXA-RGB card.
	• Supported Input resolutions are:
	- Auto: automatically detects the incoming signal. This is the
	recommended setting and should be used as the default selection.
	- 560 x 192, 560 x 384, 640 x 350, 640 x 416, 640 x 480, 720 x 532,
	800 x 600, 900 x 720, 1024 x 768, 1280 x 768, 1280 x 800, 1152 x 864,
	1280 x 1024, 1600 x 1200, HD 480p, HD, 720p, and HD 1080i.
	• Note: These displayed resolutions correspond to the supported input
	resolution of the NXA-RGB card.
	• Note: When using 1024 x 768, 1280 x 768, or 1280 x 800 it is
	recommended that you select those specific resolutions using the input
	adjustment UP/DN buttons.
Phase:	Use either the slider or the UP/DN buttons to alter the RGB tracking/signal
	level.
	• Range = 0 - 31, default = 0.
Geometry:	Provides an on-screen RGB Geometry popup dialog that allows you to select
	from several location and size adjustment settings.
	• Press the Adjust button to open the RGB Geometry popup dialog.
	• Use the Hide button to close the popup.
	• Range = 0 - 255, default = 0.
H Position
	Use the UP/DN buttons to alter the horizontal position level.
	• Range = 0 - 255, default = 0.
H Size
	Use the UP/DN buttons to alter the horizontal size level.
	• Range = 0 - 255, default = 0.
V Position
	Use the UP/DN buttons to alter the vertical position level.
	• Range = 0 - 255, default = 0.

VG-Series Modero Touch Panels 143