AMX NXD/NXT-1700VG, NXD/NXT-1500VG manual Charging the NXT-BP batteries with the NXA-BASE/B, Front

Touch Panel Accessories

NXT-BP Battery #2

Battery

Connectors

Interface connector

Battery

Connector

Port

FRONT

Battery #2 slot

NXT-BP Battery #1

Battery

Compartment

FIG. 30 Battery installation procedure

3.Align the battery connectors with the corresponding battery connector port (located inside the battery compartment), as shown in FIG. 30.

4.Insert the NXT-BP battery until the connectors securely fit into the battery connector port.

5.Repeat steps 2 through 4 for the other battery.

6.Apply a small amount of pressure to close the battery compartment until the compartment latches.

After a few seconds, the panel will turn On and the AMX logo will appear (indicating the panel is receiving power.

Charging the NXT-BP batteries with the NXA-BASE/B

1.Follow the procedures from the previous sub-section to attach the NXT touch panel to the NXA-BASE/B.

2.Insert each battery into the battery compartment shown in FIG. 30.

3.Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.

The charge status bargraph indicators, on the Battery Base page, indicate when the batteries are fully charged.

The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.

48 VG-Series Modero Touch Panels