Sanyo POA-PN03C How to enter the numbers, Fixing the network configuration, English, Item

Installation and network configuration

2Configuration for IP Address/ Sub net/ Gateway*1/DNS*2

Press SELECT button again. The following network setting pallet appears on the screen. Enter the specified network addresses.

The red frame moves sequentially left or right with 7 8 button.

The number up or down with d e but- ton.

How to enter the numbers

There are 2 ways to enter the numbers, one is by using the point buttons (d e ) on the remote control or on the projector, the other is by using the screen 10-key pallet by which the numbers can be entered directory. For further information see "How to enter the numbers with the screen 10-key pallet" (☞ p.23).

3 Fixing the network configuration

After completing the entering of address, select "SET" and press SELECT button. The network unit starts re-booting and displays message "Please wait..." on the screen until the re-booting is complete. Do not disconnect the AC

cord during this period. After that the network setting pallet will disappear on the screen.

Completing of installation

Now the installation is complete. The IP address of this projector is set to "192.168.1.201".

Item	Description
IP address	Sets IP address of the projector
Sub net	Sets Subnet mask. Normally sets 255.255.255.0
Gateway*1	Sets IP address of the default gateway (Router)
DNS*2	Sets IP address of the DNS server. Must be set when using the e-mail function
✐ Refer to the projector's owner's manual for operation of the projector.
		ENGLISH

*1 In the network environments not using a Gateway or Router, the Gateway address should be set to [0.0.0.0]. *2 If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS address.

PJ-NET ORGANIZER

OWNER'S MANUAL [XP57 Series]

21