Sanyo POA-PN03C Error information, Network Capture, Error messages, Cause and corresponding

Chapter 5 Network Capture

Error information

Error messages	Cause and corresponding
	Error when executing the communication. The parameter setting
Set up the parameter.	(host name, capture port) has not been set.
	➔ Check parameter setting (+p.71)
It has not been registered to PJ	Error when executing Start Communication or Start real time cap-
	ture. The IP address of the computer has not been registered.
as a group.
	➔ Register the IP address by using the web browser (+p.78)
	Error when executing Start Communication or Start real time cap-
Cannot be displayed as PJ is	ture. The other capture, viewer or advanced card imager function
under display.	is now operating.
	➔ Wait until the communication function is available.
	Cannot establish the connection with the network unit when
Cannot connect to PJ.	executing the Start communication, End communication, Capture
	transfer, Start real time capture or End real time capture.
	➔ Check connection of the network cable.
	Cannot transfer the data to the network unit when executing the
	Start Communication, End Communication, Capture transfer, Start
Cannot transfer data to PJ.	real time capture or End real time capture. The time out period is
	10 seconds.
	➔ Check connection of the network cable.
	Cannot receive the data from the network unit when executing
	the Start Communication, End Communication, Capture transfer,
Cannot receive data from PJ.	Start real time capture or End real time capture. The time out
	period is 10 seconds.
	➔ Check connection of the network cable.
Other PC has authority.	When executing the End communication, you cannot quit the
Cannot complete "Network
	communication because other computer has an authority
Communication".
Other PC has authority. Cannot	Other computer has an authority.
obtain authority.
The server name or address	When setting the parameter, the computer cannot find the set-
	ting host name or IP address in the network.
could not be resolved.
	➔ Use available host name or IP address.
	When setting the parameter, the reserved port number is speci-
Invalid port number	fied.
	➔ Check parameter setting (+p.71)
PJ has not started Network	The projector might have turned off during the communication.
Communication. Close the window	➔ Check projector power and restart executing "Start communica-
and open it again.	tion".

86