Sanyo POA-PN03C Change the mode of the registered projector, Status, English, Multi-control, Mode

Multi-control

Change the mode of the registered projector

To change the mode of the registered projector, select a mode with the pull-down menu button under the IP address of the target projector and then click Set button.

Mode	Operation
Control	Controlling the projector
Control & Image	Controlling and displaying images
Image	Displaying the images
OFF	Excluding from the multi-control
Delete	Deleting from the multi-control

*The multi control item is not changed during using the network viewer function. It is not available with the light mode.

Status

If some of the registered projectors are disabled by some reasons (such as disconnecting the power source, disconnecting the LAN cable, disconnecting from the network), control changes will continue to be effective for the projectors that are still active. At the same time, the deactivated projectors are excluded from the multi- control. The status of the registered projectors are indi- cated under the projector name. See the table below for status indications.

Status

Status	Description
(blank)	The projector is connected to the network correctly
No connect	The projector may not be connected to the network. Please check the connection
	and network configuration of this projector.
PIN code error	The PIN code is incorrect. The PIN code for the multi-controlled projectors must be
File Error	the same. Change the PIN code of this projector to the common PIN code.
	Not displaying the images. Check if this projector is using the Network Capture
	function or Network Viewer function individually, or in the standby mode.

* The network unit updates the status at the time when the multi-control function was executed.

✐If the multi-controlled projector is in the standby mode, any change is not effective except timer setting.

✐Cannot register, delete or change the multi-control setting during using the network viewer func- tion.

✐It is recommended that a specified projector should be chosen for setting as a master when you use this multi-control function. The control for the multi-controlled projectors will become too complicated operation if this function is used for each projector.

✐If the registered projector is not connected to the network, it will take some time to complete the multi-control operation because of waiting for the response from each registered projector.

✐There are some disabled items in the multi-control function for the light mode.

PJ-NET ORGANIZER

OWNER'S MANUAL [XP57 Series]

ENGLISH

65