TRENDnet TEG-S4000 manual Handling the Modules, Module Setup and Installation

make sure that:

The 10Base-T twisted pair Ethernet cabling is Category 3 or above.

The 100Base-TX Fast Ethernet cabling is tested Category 5.

The 1000Base-T Gigabit Ethernet cabling is tested Category 5 enhanced.

The 100Base-FX fiber cabling is 62.5/125 micron multimode fiber, or 9/125 micro single-mode fiber.

The 1000Base-SX/LX fiber cabling is 50/125, 62.5/125 multi-mode or 9/125 micron single-mode fiber.

Chapter 4. Module Installation and

Removal

WARNING

Before installing the Modules into the 4-Slot Modular Switch, you must disconnect the Switch from the main power supply.

Handling the Modules

The Module can be easily damaged by electrostatic discharge. To prevent damage, please observe the following:

Do not remove Modules from their packaging until you are ready to install it into a Switch.

Do not touch any of the pins, connections or components on the Modules.

Handle the Modules only by its edges and front panel.

Always wear an anti-static wristband connected to a suitable grounding point.

Always store or transport Modules in appropriate anti-static packaging.

Module Setup and Installation

1.Ensure that the Switch is disconnected from the main power supply and that you are wearing an anti-static wrist-band connected to a suitable grounding point.

2.Place the Switch on a flat surface. Using a small cross-bladed screwdriver, remove the blanking plate