Installation Instructions

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS Q

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

CAUTION – Unplug the

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips

Pliers

Sharp knife

screwdrivers

 

 

 

 

1/4and 5/16Nutdrivers

1ATTACH THE WATER VALVE

Locate the female connector plug (C). Plug the female connector (C) onto the male terminals on the water valve (4). Either wire can go on either terminal.

C

4

Fasten the water valve to the cabinet edge hole with the hex-head screw (13) from the kit .

DO NOT DRILL ANY ADDITIONAL HOLES.

13

Check the plastic water line nut on the bottom of the water valve to be sure it is hand tight .

DO NOT USE TOOLS.

2INSTALL WATER LINE CLAMP

Attach the water line clamp (strain relief) (8) from the kit to the refrigerator. With the clamp directly in line with the water valve, drive the screw (7) from the kit through the clamp (8) at the indent into the back of the cabinet .

7

8

The metal clamp is for the house water line (see Water Line Installation Instructions). It is not to be used for the tubing from the water valve up to the icemaker.

52

Page 53
Image 53
GE IM-6 installation instructions Water Valve Assembly Installation Instructions Q, ″ and 5/16″ Nutdrivers