Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS S

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

CAUTION – Unplug the

1PREPARE FOR INSTALLATION (cont.)

Inside the freezer, remove the two small white plug buttons (on some models) from the side wall. (If screws are present instead of plugs, leave them in place.)

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips

Pliers

Sharp knife

screwdrivers

 

 

 

 

Remove and discard the large white plug from the rear freezer wall. Pull out the gray insulation plug and remove any debris.

Remove the outlet cover with a flat-blade screwdriver.

Remove side wall plug buttons or leave screws in place

Rear wall plug button

Insulation plug

Outlet cover

1PREPARE FOR INSTALLATION

Remove the storage basket (on some models) by pulling it out to the stop position and lifting it up and out .

Note: After removing the basket, push the extension arms back into the freezer compartment .

Remove the chiller shelf (on some models) by pulling it straight out .

Remove the ice bucket

by pulling it out and lifting it up and out.

Remove the center vertical shelf support (on some models) by lifting it and rotating its bottom to the right.

2INSTALL FILL TUBE

Slide the fill tube (16) onto the

water tube inlet (15).

16

15

Go to the back of the refrigerator.

 

Remove the label covering the

 

hole. Pull out the insulation plug

 

and any debris.

 

On the tube side of the water tube inlet (15), there is an adhesive

backing. Remove the adhesive backing and slide the tube into the hole at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.

3SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Power

Switch

(Appearance may vary)

58

Page 59
Image 59
GE IM-6 installation instructions Icemaker Installation Instructions S, Prepare for Installation