GE IM-6 Icemaker Installation Instructions L, Cut the fill tube extension

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS L

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

• CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and PhillipsPliersSharp knife screwdrivers

1/4″ Nutdriver or adjustable wrench

2PREPARE FOR INSTALLATION

•Remove and discard the large white plug from the rear freezer wall.

•Remove the outlet cover with a flat-blade screwdriver.

Remove plug

3INSTALL FILL TUBE EXTENSION

• Cut the fill tube extension (10)

to the L length (refer to the
L template on page 67) with
a sharp knife or a single-edge
razor blade and slide it onto	10
the fill tube against the stop.	L

1

REMOVE ICE CUBE TRAY SHELF

•Remove the two screws securing the ice cube tray to the side wall of the freezer. Remove the tray.

•Replace the screws but do not screw them all the

way in. The screw heads should extend about 1/2″ (13 mm) from the side wall of the freezer.

4SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

34