Installation Instructions

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS G

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

CAUTION – Unplug the

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

2ATTACH THE WATER VALVE

Locate the female connector plug (B).

B

TOOLS YOU WILL NEED

Flat blade and Phillips

Pliers

Sharp knife

screwdrivers

 

 

 

 

1/4and 5/16Nutdrivers

Plug the female connector (B) onto the male terminals on the water valve wire extension (19). Either wire can go on either terminal.

Plug the female connector on the water valve wire extension (19) onto the male terminals on the water valve (4). Either wire can go on either terminal.

1REMOVE THE COVER

At the bottom rear of the refrigerator, remove the screw(s) holding the compressor compartment cover (if covered) and save for reinstallation later. Bend the cover back for access to the compartment .

B

19

4

Fasten the water valve to the cabinet edge hole using the hex-head screw (13) from the kit.

DO NOT DRILL ANY ADDITIONAL HOLES.

Check the plastic water line nut on the bottom of the water valve to be sure it is hand tight. DO NOT USE TOOLS.

13

20

Page 21
Image 21
GE IM-6 Water Valve Assembly Installation Instructions G, Locate the female connector plug B, ″ and 5/16″ Nutdrivers