GE IM-6 Icemaker Installation Instructions R, Parts Required That Came with the Refrigerator

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS R

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

•CAUTION – Unplug the

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips	Pliers	Sharp knife
screwdrivers

PARTS REQUIRED THAT CAME WITH THE REFRIGERATOR

			Phillips head
Ice bucket	Icemaker mounting block		screws (2)
Part No. WR30S1	Part No. WR2M3604	Part No. WR1M478

1PREPARE FOR INSTALLATION

•Remove all freezer baskets for greater accessibility to the rear of the freezer.

•Remove and discard the

large white plug from the rear freezer wall. Pull out the gray insulation plug and remove any debris.

•Remove the outlet cover with a flat-blade screwdriver.

54

2INSTALL FILL TUBE

•Cut the fill tube (16) to the R

length (refer to the R template	16
on page 66) with a sharp knife
or a single-edge razor blade.	15

•Slide the fill tube (16) onto the water tube inlet (15).

• Go to the back of the refrigerator.
Remove the label covering the	Lme
	lolor
hole. Pull out the insulation plug
and any debris.

• On the tube side of the water tube inlet (15) there is an adhesive backing. Remove the adhesive backing and slide the

tube into the hole near the top at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.

3SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

4INSTALL THE MOUNTING BLOCK

•Inside the freezer, remove the two small white plug buttons from the side wall.

• Using the Phillips head screws that are with the mounting block, attach the mounting block to the refrigerator by driving the screws through the outer holes on

the block and into the holes that the plug buttons were in.

•Install two self-tapping Phillips head screws (14) from the kit in the inner holes on the mounting block. On some models, the screws may already be in

place on the mounting block. The screw heads should extend about 1/2″ (13 mm) from the mounting block.