GE IM-6 installation instructions Icemaker Installation Instructions P, Water tube inlet 15 there

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS P

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

• CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips	Pliers	Sharp knife
screwdrivers

1PREPARE FOR INSTALLATION

•Remove and discard the large white plug from the rear freezer wall. Pull out the gray insulation plug and remove any debris.

•Remove the two small white plug buttons on the side wall. Install two Phillips head screws (14) in the holes that the plug buttons were in, but do not screw them

all the way in. The screw heads should extend about 1/2″ (13 mm) from the side wall of the freezer.

•Remove the outlet cover with a flat-blade screwdriver.

2INSTALL FILL TUBE

•Cut the fill tube (16) to the P

length (refer to the P template	16
on page 66) with a sharp knife
or a single-edge razor blade.	15

•Slide the fill tube (16) onto the water tube inlet (15).

•Go to the back of the refrigerator. In the upper right hand corner, remove the label covering the hole. Pull out the insulation plug and any debris.

•On the tube side of the

water tube inlet (15) there

is an adhesive backing. Remove the adhesive backing and slide the

tube into the hole near

the top at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.

3SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

14

46