GE IM-6 installation instructions Icemaker Installation Instructions Q, Install Fill Tube

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS Q

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

•CAUTION – Unplug the

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips	Pliers	Sharp knife
screwdrivers

2INSTALL FILL TUBE

•Cut the fill tube (16) to the Q

length (refer to the Q template	16
on page 66) with a sharp knife
or a single-edge razor blade.	15

•Slide the fill tube (16) onto the water tube inlet (15).

•Go to the back of the refrigerator. In the upper right hand corner, remove the label covering the hole. Pull out the insulation plug and any debris.

•On the tube side of the

water tube inlet (15) there is an adhesive backing.

Remove the adhesive backing and slide the tube into the hole near the top at

the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.

1

PREPARE FOR INSTALLATION

•Remove and discard the large white plug or foil sticker from the rear freezer wall. Pull out the gray insulation plug and remove any debris.

•Loosen the two mounting screws but do not

screw them all the way out . The screws should extend approximately 1/2″ (13 mm) out from the freezer wall.

•Remove the outlet cover with a flat-blade screwdriver.

3SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

50