15
PLUG IN THE ICEMAKER
Hold the icemaker in the freezer compartment as
shown. Insert the icemaker power cord plug (B)
into the socket on the rear wall, making sure the
prongs and holes are matched. If holes do not
match, see Step 5. Press the plug firmly into
the socket.
7
B
Installation Instructions
MOUNT THE ICEMAKER
•Lift the icemaker so the fill tube extension (10) fits
in the fill cup opening (C). Hang the icemaker on
the two mounting screws (A).
Make sure:
• The power cord is still firmly in the socket.
•The fill tube extension (10) is still in the fill cup
opening. (Check the rear of the refrigerator to
make sure the fill tube has not been pushed out
of the back of the refrigerator.)
•The icemaker mounting screws are located in
the uppermost position of the mounting slots.
THEN SECURELY
TIGHTEN THE
ICEMAKER MOUNTING
SCREWS.
9
INSTALL THE ICEMAKER FILLCUP
Install the icemaker fill cup (side-mounted) (17) into
the icemaker as shown.
6
17
INSTALL THE ICE BUCKET
Put the ice bucket (11)
directly under the
icemaker (to the left
and all the way to the
rear of the shelf under
the icemaker).
The straight 2-
position
shelf should
be in the
lower position.
The step
shelf’s lower step should
be under the icemaker.
The cantilever shelf’s top hooks should be in the
6th slot up from the bottom of the track.
Make sure the icemaker power switch is set to OFF.
10
11
ATTACHWARRANTY LABEL
A label (9) is provided with this kit to record the date
of installation for warranty purposes. Apply it to the
back of the refrigerator.
11
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner’s Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
12
10
A
C
REINSTALL THE ELECTRIC PLUGCOVER
If the plug cover removed in Step 1 matched
Figure 1, continue to Step 9.
If the plug cover removed in Step 1 matched
Figure 2, it must be reinstalled.
• Remove the break-out tab on the left side of
the cover. Hold the cover and twist off the tab
with pliers.
• Place the cover over the electric plug with the
power cord running through the opening.
• Insert the tabs in the top or bottom and snap
the other end in place.
IMPORTANT: This cover will help keep the electric
plug from coming out of the socket when mounting
the icemaker. Be sure to install it now.
8