Dell C6100 System Memory, Installing the Infiniband Mezzanine Card, Supported Dimm Configuration

Installing the Infiniband Mezzanine Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Place the mezzanine card on the system-board assembly. See Figure 3-14 and Figure 5-11.

2Replace the three screws that secure the mezzanine card to the back of the system board tray. See Figure 3-14.

3Replace the screw that secures the mezzanine card side bracket to the system board tray. See Figure 3-14.

4Replace the system-board assembly. See "Installing a System-BoardAssembly" on page 62.

5Reconnect all the cables to the mezzanine card.

6Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.

System Memory

Each system board has twelve unbuffered or registered DDR3-DIMM slots for the installation of up to twelve DDR3-1066/1333 memory chips to support processor 0 and processor 1. See "System Board Connectors" on page 129 for the location of the memory modules.

Supported DIMM Configuration

For the sequence of the twelve DIMM sockets, see Figure 3-15. When you insert the DIMM(s), always start with DIMM0_CHA. See Table 3-2 for possible memory configurations.

Installing System Components

77