
IDE Configuration
NOTE: The AHCI Port is shown in SETUP screen when it is in the Enhanced AHCI or RAID mode.
Option | Description |
|
|
Configure SATA as | Configures the SATA: |
| • IDE |
| – SATA#1 Configuration (Enhanced default) |
| Configures SATA#1. |
| – SATA#2 Configuration (Enhanced default) |
| Configures SATA#2. |
| • Primary Master/Slave is SATA Port 0/2 |
| • Secondary Master/Slave is SATA Port 1/3 |
| • AHCI/RAID |
| • AHCI Port 0~5 |
|
|
Hard Disk Write Protect | Enables or disables device write protection. This is |
(Disabled default) | effective only if the device is accessed through BIOS. |
|
|
IDE Detect Time Out (Sec) | Selects the time out value for detecting |
(35 default) | ATA/ATAPI device(s). |
|
|
Primary IDE Master
To configure Primary, Secondary, Third or Fourth device on the IDE channel.
Option | Description |
|
|
Device | Displays the type of device assigned to this channel. |
|
|
Vendor | Displays the manufacturer's name of the device. |
|
|
Size | Displays the size of the device (GB). |
|
|
LAB Mode: | Indicates whether LAB access mode is supported or |
| not supported. |
|
|
Block | Indicates whether |
Transfer) (Auto default) |
|
|
|
PIO Mode (Auto default) | Indicates whether PIO mode is supported. |
Using the System Setup Program
41