Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS H

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

NOTE: If you have refrigerator model TNS22 or TNX22, please refer to the installation instructions for P , instead of using the H instructions.

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips

Pliers

Sharp knife

screwdrivers

 

 

 

 

1PREPARE FOR INSTALLATION

Remove and discard the white plug from the upper left corner of the freezer wall.

Remove plug

2INSTALL WATER TUBE INLET

Locate the hole in the upper right corner on the back of the refrigerator and, using a knife, clear the foil from the hole.

Remove the gray insulation plug from the hole. NOTE: It may be necessary to remove the screw from the top right condenser mounting clip for better access to the hole (see page 25, Step 4).

Cut the fill tube (16) to the H length (refer to the H template on page 66), with a sharp knife or a

single-edge razor blade.

Slide the fill tube (16) onto

16

the water tube inlet (15).

 

On the tube side of the water

15

tube inlet (15) there is an

 

adhesive backing. Remove

 

the backing. Slide the tube

 

into the hole on the back

 

of the refrigerator as

 

shown. Firmly press on

 

the inlet to secure it .

 

3REMOVE PLUG COVER

• Remove the electric plug cover from the left side wall and discard it.

• Remove the screw and pull the cover off.

4LOOSEN MOUNTING SCREWS

Loosen the two mounting screws (A) but do not screw them all the way out . The screws should extend approximately 1/2(13 mm) out from the freezer wall.

A

5SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

22

Page 23
Image 23
GE IM-6 installation instructions Icemaker Installation Instructions H, Remove the screw and pull the cover off