GE IM-6 Icemaker Installation Instructions N, Go to the back of the refrigerator

Installation Instructions

ICEMAKER INSTALLATION INSTRUCTIONS N

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

•CAUTION – Unplug the

Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips	Pliers	Sharp knife
screwdrivers

1REMOVE ICE CUBE TRAY SHELF

•Remove the two screws securing the ice cube tray to the side wall of the freezer. Remove the tray.

•There are two white plug buttons above the screw holes. Remove these plug buttons and install them in the two screw holes that were used to hold the ice cube tray shelf.

•Install two Phillips head screws (14) in the holes that the plug buttons were in, but do not screw

them all the way in. The screw heads should extend about 1/2″ (13 mm) from the side wall of the freezer.

14

Plug

Buttons

2PREPARE FOR INSTALLATION

•Remove and discard the large white plug from the rear freezer wall. Pull out the gray insulation plug and remove any debris.

•Remove the outlet cover with a flat-blade screwdriver.

3INSTALL FILL TUBE

•Cut the fill tube with foil (16) to the N length (refer to the N template on page 66) with a sharp knife or a single-edge razor blade.

•Slide the fill tube with foil (16)

onto the water tube inlet (15).	16
• Go to the back of the refrigerator.	15
On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top
at the back of the refrigerator.
Firmly press on the inlet to
secure it to the refrigerator.

4SET POWER SWITCH TO OFF

Set the icemaker power switch to OFF. Leave the power switch in the OFF position until the refrigerator is connected to the water supply to prevent premature operation.

Hole for wire tie

Power

Switch

(Appearance may vary)

42