Extron electronic Installation and Operation, Installation Overview, Mounting the YCS SW2

Installation and Operation

Installation Overview

To install and set up the YCS SW2, follow these steps:

1Mount the YCS SW2 on a rack shelf, furniture, or projector if desired.

Rack mounting

For optional rack mounting, do not install the rubber feet. Mount the switcher on a 19” wide 1U VersaTools® rack shelf (Extron part #60-190-20 or 60-604-20), a standard 1U Universal or Basic rack shelf (Extron part #60-190-01 or 60-604-01), or

2

Connect your composite video and/or S-video input source(s) to one or both YCS input connectors.

a Universal or Basic 1U 6-inch Deep Rack Shelf (Extron part #60-190-10 or 60-604-10).

3Connect your output device(s) to the YCS composite video and/or S-video output connector(s).

4Wire the provided 2-pin captive screw connector to the external power supply. (See Wiring the Power Connector, later in this chapter.)

5If using autoswitching, insert the provided 5-pin captive screw plug into the 5-pin connector on the YCS back panel, and jumper-connect pins 4 and 5 together. (See Autoswitching, later in this chapter.)

6If using contact closure for input selection, connect a two- button remote contact closure device to pins 1, 2, and 3 of the captive screw connector on the YCS rear panel. (See Contact Closure, later in this chapter.)

7Apply power to the YCS SW2 and to the input and output devices.

Mounting the YCS SW2

The YCS SW2 can be set on a table; mounted on a rack shelf; mounted under a desk, podium, or table; or attached to a projector.

Tabletop use

Four self-adhesive rubber feet are included with the YCS SW2. For tabletop use, attach one foot at each corner on the bottom of the unit, and place the YCS in the desired location.

Mounting on a standard or VersaTools rack shelf

1.	If feet were previously attached to the bottom of the YCS,
	remove them.
2.	Mount the YCS SW2 on the rack shelf, using two 4-40 x
	3/16” screws in opposite (diagonal) corners to secure the
	unit to the shelf (see figure 2-1, below).
3.	Install blank panel(s) or other unit(s) on the rack shelf as
	desired.

VersaTools Rack Shelf

1/4 Rack Width Front

False Faceplate

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16" Screws

Figure 2-1 — Mounting a YCS SW2 (with other units) on a VersaTools rack shelf

2-2 YCS SW2 • Installation and Operation YCS SW2 • Installation and Operation 2-3