Installation and Operation, cont’d
11. If desired, choose one of the provided four sizes of self- adhesive cover sheets, and apply it to the underside of the mounting tray.
PMK 300 Projector Mount Kit
The PMK 300
Follow these steps to
1. | If necessary, remove the feet from the bottom of the YCS. |
2. | Mount the YCS to one of the bracket’s three mounting |
| plates. It can be vertically mounted facing either up or |
| down, whichever is most convenient. See figure |
| • On the side mounting plates, the YCS is typically |
| mounted on the outside of the bracket. |
| On the front mounting plate, the device is typically |
| mounted on the inside of the bracket. |
| • For the YCS SW2 unit, use two of the supplied |
| Rubber Pad | |
Multi Product | ||
Projector Mounting Kit | ||
|
Figure
| 3/16 screws in opposite (diagonal) corners to secure |
| the device to the bracket. |
| For the YCS power supply, use the two included tie |
| wraps to strap the power supply to the bracket. |
3. | Place the |
| legs of the |
| mounting plate, then through the round holes on the |
| backing brace. |
| • For a typical (1.5” to 2.0” diameter) pole — You can |
| use the supplied square |
| ceiling pole. |
Rear Panel Features
| 2 | 4 | 6 | |
| INPUTS | OUTPUT |
| |
POWER | 1 | VIDEO | Y | |
12V | ||||
|
|
| ||
0.3A MAX |
|
|
| |
1 |
|
|
| |
| 2 | C |
YCS SW2
CONTACT
7
1 2
| • For a smaller or larger pole — Locally obtain a square |
| |
| the bracket can accomodate a square |
| sizes from 1.0” to 2.5” in diameter. |
4. | Secure the bracket to the |
| nuts, washers, and lock washers. Tighten the hex nuts just |
| enough that they can be loosened by hand. |
3 5
Figure 2-10 — YCS SW2 rear panel
1Power connector — Plug the external 12 VDC power supply into this
2Input 1 connector — Connect a composite video input source to this BNC connector.
3Input 2 connector — Connect an
| YCS SW2 • Installation and Operation |