Extron electronic YCS SW2 user manual Furniture mounting, Projector mounting

Installation and Operation, cont’d

Figure 2-5 — Mounting the YCS SW2 to a back rack support

Furniture mounting

To furniture-mount the YCS SW2, use the optional VersaTools under-desk mounting kit (part #70-212-01), as follows.

1.	If rubber feet were previously attached to the bottom of the
	unit, remove them.
2.	Remove the two screws from one side of the YCS. Retain
	the screws for possible later reassembly.
3.	Attach one bracket to the side of the unit, using the
	provided machine screws (see figure 2-6, below).

Figure 2-6 — Preparing the YCS SW2 for under-desk mounting

2-6 YCS SW2 • Installation and Operation

4.	Repeat steps 2 and 3 on the other side of the YCS.
5.	Hold the unit with the attached brackets against the
	underside of the table or other furniture. On the mounting
	surface, mark the location of the bracket’s screw holes.
6.	Drill 3/32” (2 mm) diameter pilot holes, ¼” (6.3 mm) deep
	in the mounting surface at the marked screw locations.
7.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until slightly less
	than ¼” of the screw head protrudes.
8.	Align the mounting screws with the slots in the brackets
	and place the unit against the surface, with the screws
	through the bracket slots.
9.	Slide the unit slightly forward or back, then tighten all four
	screws to secure it in place.

Projector mounting

To projector-mount the YCS SW2, three optional mounting kits are available for use with the YCS SW2.

PMK 100 Mini Projector Mount Kit

The PMK 100 is a projector mounting kit (part # 70-217-01) designed for use with Extron 1U high, quarter-rack width products like the VersaTools products. It allows them to be mounted near or on a projector support.

Follow these steps to projector-mount the YCS SW2 using the PMK 100 kit:

1.	If rubber feet were previously attached to the bottom of the
	unit, remove them.
2.	Remove the two screws from one side of the YCS. Retain
	the screws for possible later reassembly.
3.	Attach the projector mounting bracket to the side of the
	unit, using the provided machine screws.

YCS SW2 • Installation and Operation 2-7