GE IM-6 Water Valve Assembly Installation Instructions C, Remove the Cover, 16″ Nutdriver

Installation Instructions

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS C

Are these the right instructions for your model? Follow the Installation Instructions indicated by the label on the back of the refrigerator— C F G H J K L M N P Q R S or T

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

• CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet .

TOOLS YOU WILL NEED

Flat blade and Phillips	Pliers	Sharp knife
screwdrivers

5/16″ Nutdriver

1REMOVE THE COVER

At the bottom rear of the refrigerator, remove the screw(s) holding the compressor compartment cover (if covered) and save for reinstallation later. Bend the cover back for access to the compartment.

2ATTACH THE WATER VALVE

•Locate the female connector plug (A) which is attached to the cabinet with a wire tie. Remove the wire tie and discard it .

Wire tie

A

•Remove and discard the tape from the female connector (A) and plug onto the male terminals on the water valve (4). Either wire can go on either terminal.

A

4

•Fasten the water valve to the cabinet edge hole using the hex-head screw (13) from the kit .

DO NOT DRILL ANY ADDITIONAL HOLES.

•Check the plastic water line nut on the bottom of the water valve to be sure it is hand tight .

DO NOT USE TOOLS.

13

12