6.Repeat steps 1 and 2 to ensure that the range foot is engaged in the
If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, the
Level Range
Determine if you have AquaLift® Technology or Steam Clean by referring to the “Range Care” section of the User Instructions.
For Ranges with AquaLift® Technology or Steam Clean:
1.Place level on the oven bottom as indicated in one of the two figures below depending on the size of the level. Check with the level: side to side and front to back.
2.If range is not level, pull range forward until rear leveling leg is removed from the
3.Follow the directions in Style 1 or Style 2, depending on the style of drawer supplied with the range.
For Ranges without AquaLift® Technology or Steam Clean:
1.Place a standard flat rack in oven.
2.Place level on the rack and check levelness of the range, first side to side; then front to back.
Warming Drawer or Premium Storage
Drawer
(on some models)
Remove all items from inside the warming drawer or premium storage drawer, and allow the range to cool completely before attempting to remove the drawer.
To Remove:
1.Open the warming drawer or premium storage drawer to its fully open position.
2.Using a
A
B
C
A.
B. Drawer alignment tab
C. Drawer glide notch
3.Repeat Step 2 on the other side. The warming drawer or premium storage drawer is no longer attached to the drawer glides. Using both hands, pick up the warming drawer or premium storage drawer to complete the removal.
3.If range is not level, pull range forward until rear leveling leg is removed from the
4.Follow the directions in Style 1 or Style 2, depending on the style of drawer supplied with the range.
Style 1: Ranges Equipped with a Storage Drawer:
Use a ¼" drive ratchet, wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the
Style 2: Ranges Equipped with a Warming Drawer or Premium Storage Drawer:
Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the
NOTE: Range must be level for satisfactory baking performance and best cleaning results using AquaLift® Technology and Steam Clean functions.
To Replace:
1.Align the forward drawer notches with the notches in the drawer glides on both sides. Place the rear alignment tabs into the drawer glides on both sides.
A
B
A. Drawer alignment tab
B. Drawer glide notch
2.Push the warming drawer or premium storage drawer in all the way.
3.Gently open and close the warming drawer or premium storage drawer to ensure it is seated properly on the glides on both sides.
13