Whirlpool W10403811C wire connection Power Supply Cord, Style 2 Direct wire strain relief, A B C

Style 2: Direct wire strain relief

■Remove the knockout as needed for the flexible conduit connection.

■Assemble a UL listed conduit connector in the opening.

A

B

A. Removable retaining nut

B.Conduit

■Tighten strain relief screw against the flexible conduit.

5.Complete installation following instructions for your type of electrical connection:

4-wire(recommended)

3-wire(if 4-wire is not available)

Electrical Connection Options

If your home has:	And you will be	Go to Section:
	connecting to:
4-wire receptacle	A UL listed,	4-wire connection:
(NEMA type 14-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord
4-wire direct	A circuit breaker	4-wire connection:
³⁄₈"	box or fused	Direct wire
	disconnect
(1.0 cm)
5"
(12.7 cm)
3-wire receptacle	A UL listed,	3-wire connection:
(NEMA type 10-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord

If your home has:	And you will be	Go to Section:
	connecting to:
3-wire direct	A circuit breaker	3-wire connection:
³⁄₈"	box or fused	Direct wire
	disconnect
(1.0 cm)
3"
(7.6 cm)

4-wire connection: Power Supply Cord

Use this method for:

■New branch-circuit installations (1996 NEC)

■Mobile homes

■Recreational vehicles

■In an area where local codes prohibit grounding through the neutral

1.Part of metal ground strap must be cut out and removed.

A

B

C

A. Metal ground strap

B.Discard

C.Ground-link screw

2.Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw.

3.Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block.

A

B

C

D

A. Terminal block

B.Ground-link screw

C.UL listed strain relief

D.Power supply cord wires

9