Hearth and Home Technologies PALOMA-GR, PALOMA-BL Front Door Glass Assembly Installation

M. Front Door Glass Assembly Installation

Remove the front door assembly by pulling bottom of front away from appliance and lifting it off of the spring-loaded latches on top of the appliance (see Figure 8.35).

Figure 8.35

Position the four flat 1/4 in. (6 mm) spacer washers on the front door so that the four mounting screws pass through them. Position the glass over the front door.

Install the four protective barrels into the glass and the four nylon washers on top of the glass.

From inside the door front, pass the screws through to the outside and thread on the caps until tight. See Figure 8.36.

CAP AND BARREL FASTENER SYSTEM

	Nylon washer on back
Screw	and front of glass
	Finishing Cap
	Protective barrel sleeve
	through hole in the glass

of side Back door front

Figure 8.36

N. Inner Glass Door Assembly Replacement

Turn the appliance OFF and let it cool down before replac- ing the inner glass door assembly.

With the front door assembly removed from the appliance, remove the inner glass door assembly by disengaging the spring-loaded latches at the bottom of the appliance and lifting off of the two spring-loaded latches at the top of the appliance.

Replace with a new inner glass door assembly.

Figure 8.37 Complete Assembly

WARNING

Handle glass doors with care.

• Inspect the gasket to ensure it is undamaged.

• Inspect the glass for cracks, chips or scratches.

•Do NOT strike, slam or scratch glass.

•Do NOT operate appliance with glass door removed, cracked, broken or scratched.

•Replace glass door assembly as a complete appliance.

44 Heat & Glo • Paloma • 7031-220 Rev. P • 10/08