Hearth and Home Technologies PALOMA-GY, PALOMA-GR, PALOMA-BL, PALOMA-BZ owner manual Vinyl Siding

	VINYL SIDING
	APPLY SEALANT TO
	ALL FOUR SIDES
	SCREWS
	BOLT HORIZONTAL TOP
	TO VINYL STANDOFF
	SCREWS
WALL
THIMBLE	VINYL SIDING STANDOFF WITH
COVER	SIDING BENEATH REMOVED
	WALL THIMBLE

Figure 5.8

11.Place the wall thimble cover over the pipe assembly and slide the appliance and vent assembly towards the wall, carefully inserting the vent pipe into the vent termination cap assembly. It is important that the vent pipe extend into the vent termination cap a sufficient distance so as to result in a minimum pipe overlap of 1-1/4 in. (32 mm). Secure the connection between the vent pipe and the vent termination cap by attaching the two sheet metal strips extending from the vent termination cap assembly into the outer wall of the vent pipe. Use the two sheet metal screws provided to connect the strips to the pipe section (Figure 5.9).

1/4 in. (6 mm)

FOLD STRAP

HERE

SHEET METAL

SCREW

	WALL
WALL THIMBLE COVER/CEILING	THIMBLE
FIRESTOP AS REQUIRED BY
LOCAL JURISDICTION	STRAP

Figure 5.9

Note: The attachment from the vent pipe to the vent termination cap must be sealed with silicone. Termination caps shall not be recessed into a wall or siding.

WARNING

Fire Risk

Exhaust Fumes Risk

Impaired Performance of Appliance

•Ensure vent components are locked together correctly.

•Pipe may separate if not properly joined.

WARNING

Do NOT connect a pipe section to a termination cap without using the telescoping flue section found on the termination cap.

WARNING

Burn Risk

• Local codes may require installation of a cap shield to prevent anything or anyone from touching the hot cap.

Heat & Glo • Paloma • 7031-220 Rev. P • 10/08 15