Correct

Important Satellite Connection Information

For Mono (& 70V Mono) Systems

For Mono systems, always connect half the satellite speakers to one of the satellite speaker output terminals and the other half to the

other satellite speaker output terminals. Do NOT connect to only one of the sets of satellite output terminals..

In order to avoid excessively low impedance loads to the power amp when using 4 satellite speakers (which could cause the power amplifier to fail), the satellite output terminals of the SB-210 in mono mode are connected in series with each other. This requires that speakers be connected to both sets of satellite output terminals, and that the load on each satellite output be matched.

Otherwise, there will be very little or no sound coming from the satellite speakers

Left

Satellite

Outputs

Right	Left

Satellite

Outputs

Right

	
CORRECT	WRONG

For systems with 2 satellite speakers, put 1 on each set of the subwoofer’s satellite output terminals (shown).

For systems with 4 satellite speakers, put 2 on each set of the subwoofer’s satellite output terminal

All satellite speakers on one of the sets of satellite output terminals and none on the other satellite output terminals.

WRONG