|
|
| Troubleshooting |
RADIO RECEPTION |
|
| |
|
|
|
|
| Radio reception is poor. | – | If the signal is too weak, adjust the antenna or |
|
|
| connect an external antenna for better reception. |
|
| – Increase the distance between the Mini HiFi | |
|
|
| System and your TV or VCR. |
|
|
|
|
TAPE OPERATION/RECORDING |
|
| |
|
|
|
|
| Recording or playback cannot be made. | – | Clean deck parts, see “Maintenance”. |
|
| – Use only NORMAL (IEC I) tape. | |
|
| – Apply a piece of adhesive tape over the missing | |
|
|
| tab space. |
|
|
|
|
| The tape deck door cannot open. | – | Remove and reconnect the AC power plug and |
|
|
| switch on the system again. |
|
|
|
|
GENERAL |
|
| |
|
|
|
|
| The system does not react when buttons | – | Remove and reconnect the AC power plug and |
| are pressed. |
| switch on the system again. |
|
|
|
|
| Sound cannot be heard or is of poor | – | Adjust the volume. |
| quality. | – | Disconnect the headphones. |
|
| – Check that the speakers are connected correctly. | |
|
| – Check if the stripped speaker wire is clamped. | |
|
| – Make sure the | |
|
|
| |
|
|
| at 48 kHz, 44.1 kHz or 32 kHz. |
|
|
|
|
| The left and right sound outputs are | – | Check the speaker connections and location. |
| reversed. |
|
|
|
|
|
|
| The remote control does not function | – | Select the source (CD or TUNER, for example) |
| properly. |
| before pressing the function button (É,í,ë). |
|
| – Reduce the distance between the remote control | |
|
|
| and the system. |
|
| – Insert the batteries with their polarities | |
|
|
| (+/– signs) aligned as indicated. |
|
| – | Replace the batteries. |
|
| – Point the remote control directly towards the IR | |
|
|
| sensor. |
|
|
|
|
| The timer is not working. | – | Set the clock correctly. |
|
| – Press and hold CLOCK•TIMER to switch on the | |
|
|
| timer. |
|
| – If recording or tape dubbing is in progress, stop | |
|
|
| recording. |
|
|
|
|
| Not all lighted buttons are showing light. | – | Press DIM to select DIM OFF display mode. |
|
|
|
|
| The Clock/Timer setting is erased. | – | Power has been interrupted or the power cord |
|
|
| has been disconnected. Reset the clock/timer. |
|
|
|
|
| The system displays features | – | Press and hold Çon the system to switch off |
| automatically and buttons start flashing. |
| the demonstration. |
|
|
|
|
English
29