John Lewis JLDWW 906 Setting the water softener, Setting manually, Setting electronically

	Water hardness			Adjusting the water hardness
					setting
Clarke		°TH	mmol/l	manually		electronically
< 5		< 7	< 0,7	1		level 1

Use of salt

no

Setting the water softener

The water softener must be set in two ways: manually, using the water hardness dial and electronically.

Setting manually

The dishwasher is factory set at position 2.

1.Open the dishwasher door.

2.Remove the lower basket from the dishwasher.

3.Turn the water hardness dial to position 1 or 2 (see table above).

4.Replace the lower basket.

2.Simultaneously press and hold function buttons B and C, until the lights Glass, Rinse hold and Multi tab start flashing.

3.Press function button A, the lights of function buttons Rinse hold and Multi tab turn off while the light of function button Glass continues to flash. The current level shows on the digital display.

Examples:

displayed = level 5

displayed = level 10

4.To change the level, press function button A. Each time the button is pressed the level changes. (For the selection of the new level see the chart).

Examples:

If the current level is 5, by pressing function button A once, level 6 is selected, if the current level is 10, by pressing function button A once, level 1 is selected.

5.To memorise the operation, switch off the dishwasher by pressing the On/Off button.

Setting electronically

The dishwasher is factory set at level 5.

1.Press the On/Off button. The dishwasher must be in setting mode.

12