hussman P/N IGUP-AB-0904 Waste Outlet and P-TRAP, Location Uncrating the Stand, Exterior Loading

Page 6

IGUP-AB-0904

 

Installation

LOCATION

UNCRATING THE STAND

The refrigerated merchandisers have been designed for use only in air conditioned stores where temperature and humidity are maintained at or below 75°F and 55% rela- tive humidity. DO NOT allow air conditioning,electric fans, ovens, open doors or windows (etc.) to create air cur- rents around the merchandiser, as this will impair its cor- rect operation.

Product temperature should always be maintained at a constant and proper temperature. This means that from the time the product is received, through storage, prepa- ration and display, the temperature of the product must be controlled to maximize life of the product.

Place the fixture as close to its permanent position as possible. Remove the top of the crate. Detach the walls from each other and remove from the skid. Unbolt the case from the skid. The fixture can now be lifted off the crate skid. Lift only at base of stand!

EXTERIOR LOADING

These models have not been structurally designed to sup- port excessive external loading. Do not walk on their tops; This could cause serious personal injury and dam- age to the fixture.

DO NOT SEAL JOINT TRIM TO FLOOR!

Plumbing

WASTE OUTLET AND P-TRAP

The waste outlet is located off the center of the case on one side allowing drip piping to be run lengthwise under the fixture.

A P-trap must be installed to prevent air leakage and in- sect entrance into the fixture. (P-traps are not supplied with these cases.)

NOTE: PVC-DWV solvent cement is recommended. Follow the manufacturer’s instructions.

INSTALLING CONDENSATE DRAIN

Poorly or improperly installed condensate drains can se- riously interfere with the operation of this refrigerator, and result in costly maintenance and product losses. Please follow the recommendations listed below when installing condensate drains to insure a proper installation:

1.Never use pipe for condensate drains smaller than the nominal diameter of the pipe or P-trap supplied with the case.

2.When connecting condensate drains, the P-trap must be used as part of the condensate drain to prevent air leakage or insect entrance. Store plumb- ing system floor drains should be at least 14" off the center of the case to allow use of the P-trap pipe section. Never use two water seals in series in any

one line. Double P-traps in series will cause a lock and prevent draining.

3.Always provide as much down hill slope (“fall”) as possible; 1/8" per foot is the preferred minimum. PVC pipe, when used, must be supported to main- tain the 1/8" pitch and to prevent warping.

4.Avoid long runs of condensate drains. Long runs make it impossible to provide the “fall” necessary for good drainage.

5.Provide a suitable air break between the flood rim of the floor drain and outlet of condensate drain. 1" is ideal.

6.Prevent condensate drains from freezing:

a.Do not install condensate drains in contact with non-insulated suction lines. Suction lines should be insulated with a nonabsorbent insulation material such as Armstrong’s Armaflex.

b.Where condensate drains are located in dead air spaces (between refrigerators or between a refrigerator and a wall), provide means to prevent freezing.The water seal should be insulated to prevent condensation.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents REV Upright Meat Display CaseApparent Loss or Damage This Booklet Contains Information onShipping Damage Concealed Loss or DamageImportant Information Cut & Plan Views NSF Installation Requirement Location Uncrating the Stand Installing Condensate DrainWaste Outlet and P-TRAP Exterior LoadingPlease Read ALL Instructions Before Beginning Installation Start-up,Testing andAdjustment ProceduresWarranty Conditions Technical Procedures are NOW CompleteIGUP-AB-0904 System maintenance and cleaning See also Remote timer operationSee also cdtachedTimerController Settings Models SCH & Schms Emitter Nozzle Cleaning Instructions Trouble Shooting Guide Major System ComponentsStat Location Wiring Color Code Ashrae Color CodeNON-GLARE Glass User InformationUser Information, Cont’d Before calling for service, check the following Electrical PrecautionsTips & Troubleshooting Replacing Fluorescent LampsElectrical Schematics W0050001W0050002 SensingRemotebulb CoilGravity Duplex Compressor Motor Appendix B. Application Recommendations Refrigerated Appendix A. Temperature Guidelines RefrigeratedType Typical Entering Refrigerator AIR Temperature Appendix C. Field Recommendations RefrigeratedAppendix D. Recommendations To User Refrigerated Appendices, Cont’d Rev Limited Warranty Model Serial Number

P/N IGUP-AB-0904 specifications

The Hussman P/N IGUP-AB-0904 is a sophisticated glass showcase designed to meet the demanding needs of modern retail environments, particularly in the grocery and foodservice sectors. This model exemplifies the essence of efficiency, aesthetics, and technology integration, making it a preferred choice for businesses aiming to enhance product presentation while maintaining optimal temperature control.

A key feature of the IGUP-AB-0904 is its sleek glass design, which provides an unobstructed view of the products displayed. The showcase utilizes high-performance tempered glass to ensure durability and insulation, crucial for maintaining freshness in perishable goods. The panoramic visibility not only attracts customers but also enhances product appeal, encouraging impulse purchases.

One of the standout technologies integrated into this unit is advanced refrigeration. The unit employs a state-of-the-art cooling system that ensures even temperature distribution, effectively preserving the quality of various items, from dairy products to deli meats. The IGUP-AB-0904 also supports energy-efficient operations, reducing overall energy consumption while still delivering optimal cooling performance.

The display area is thoughtfully designed for easy accessibility, featuring adjustable shelving that accommodates a wide range of product sizes and types. Retailers can customize the arrangement to suit different displays, allowing for flexibility in merchandising strategies. The illumination provided by LED lighting enhances product visibility, creating an inviting atmosphere that draws customers in.

Another noteworthy characteristic of the Hussman IGUP-AB-0904 is its user-friendly controls. The digital control panel allows for precise management of temperature settings, ensuring that all items are stored under ideal conditions. Additionally, the unit includes an automatic defrost feature, minimizing maintenance requirements and ensuring uninterrupted service.

Durability is a hallmark of the IGUP-AB-0904, constructed with high-quality materials designed to withstand the rigors of a busy retail environment. The showcase's robust design also makes it easy to clean, maintaining hygiene standards essential for food displays.

In summary, the Hussman P/N IGUP-AB-0904 is a top-tier display showcase that combines innovative technology with practical design. Its features—such as exceptional visibility, energy-efficient cooling, adjustable shelving, and user-friendly controls—make it an excellent investment for retailers looking to elevate their product presentation while ensuring optimal preservation of perishable goods.
Top Page Image Contents