ENGLISH | 15 |
1.Make sure that the detergent tablets are applicable for your water hardness. Refer to the instructions from the manufacturer.
2.Set the lowest levels of water hardness and rinse aid dosage.
It is not necessary to fill the salt container and the rinse aid dispenser.
Do these steps when the drying results are not satisfactory:
1.Fill the rinse aid dispenser with rinse aid.
2.Set the rinse aid dosage to position 2.
Do these steps to use the detergent powder again:
1.Fill the salt container and the rinse aid dis- penser.
2.Set the water softener to the highest level.
3.Do a washing programme without dishes.
4.Adjust the water softener. Refer to the chapter 'Setting the water softener'.
5.Adjust the rinse aid dosage.
Different brands of detergent dissolve in different times. Some detergent tablets do not have the best cleaning results during
short washing programmes. Use long washing programmes when you use detergent tablets to fully remove the detergent.
Setting and starting a washing programme
Set the washing programme with the door ajar. The washing programme only starts after you close the door. Until then it is
possible to modify the settings.
Do these steps to set and start a washing pro- gramme:
1.Switch on the appliance.
2.Make sure that the appliance is in setting mode.
3.Press the programme selection/cancel button again and again to set the washing programme. Refer to the chapter 'Washing programmes'.
–The programme indicator light comes on.
4.Close the door.
–The washing programme starts auto- matically.
When the washing programme operates, you cannot change the programme. Can-
cel the washing programme.
Warning! Only interrupt or cancel a washing programme if necessary.
Caution! Open the door carefully. Hot steam can come free.
Cancelling a washing programme
1.Press and hold the programme selection/ cancel button for approximately 3 seconds.
–The programme indicator light goes off.
–The end indicator light starts to flash.
2.Release the programme selection/cancel button to cancel the washing programme.
At this time you can do these steps:
1.Switch off the appliance.
2.Set a new washing programme.
Fill the detergent dispenser with detergent be- fore you set a new washing programme.
Interrupting a washing programme
Open the door.
•The programme stops. Close the door.
•The programme continues from the point of interruption.
End of the washing programme
Switch off the appliance in these conditions:
•The appliance stops automatically.
•The audible signals for the end of the pro- gramme operate.
1.Open the door.
–The end indicator light comes on.
–The programme indicator light stays on.
2.Press the on/off button.