IKEA DW60 manual Water connection

Page 20

ENGLISH

If a repair is necessary, the appliance must be easily accessible for the engineer.

Put the appliance adjacent to a water tap and a drain.

Water connection

This appliance has a special inlet hose for water stop later defined as aqualock.

Water inlet hose

Connected the appliance to a hot (max. 60°) or cold water supply.

If the hot water comes from alternative sources of energy that are more environmentally friendly (e.g. solar or photovoltaic panels and aeolian), use a hot water supply to decrease energy consumption.

Connect the inlet hose to a water tap with an external thread of 3/4".

Caution! Do not use connection hoses from an old appliance.

Caution! If you connect the appliance to new pipes or pipes that are not used for

a long time, we recommend to run the water for some minutes before you connect the inlet hose.

Aqualock inlet hose

The inlet hose is a high pressure resistant. It can hold pressure at maximum 6 MPa. From ex- ternal the inlet hose has a sheathing against eventual damages. If the inner hose breaks, the water that is in the hose will became dark. You can see it across the special transparent sheathing. Turn off the water tap immediately and contact the After Sales Service.

20

For the venting of the dishwasher only water fill, water drain and power supply cable open- ings are necessary.

A

B

The aqualock inlet

Turn the inlet hose to

hose is installed with

the left or the right to

a

safety

device to

suit

the installation.

prevent

accidental

Tight the locknut cor-

loosening. To discon-

rectly to prevent wa-

nect the hose:

ter leaks.

 

Press the lever ( B ).

 

If you use a inlet

Turn the retaining

 

 

hose

extension

 

ring ( A ) anticlock-

the

 

total

reached

 

wise.

 

length must be no

longer than 4 metres.

Drain hose

If you connect the water drain hose to a water trap under the A sink, remove the plastic membrane

(A). If you do not re- move the membrane, remaining food can cause a blockage in the drain hose spigot.

Caution! Make sure that the

water couplings are tight to prevent wa- ter leakage.

Image 20
Contents Renlig GB DW60Page ENGLISH4 Contents Safety informationEnglish Product description Control panel English Washing programmes Setting the water softener Use of the applianceProgramme Programme duration Energy consumption Water Minutes KWh LitresDishwashers cause damage to the water softener Use of dishwasher saltTypes of salt that are not applicable for Use of rinse aid Loading cutlery and dishesEnglish Use of detergent Setting and starting a washing programme Cel the washing programme Cancelling a washing programmeCare and cleaning Malfunction Dishwasher does not fill with wa- ter Running pro- gramme Intermittent audi- ble signal What to do if… Not clean Not applicable for the type of load Soil StalledQuantity of detergent is too little Or missingTechnical data InstallationWater connection Electrical connection Environment concernsNormal wear and tear Transportation damagesEnglish Page Page Page Page 156988030-00-012009 Inter Ikea Systems B.V AA-401733-1
Related manuals
Manual 16 pages 56.42 Kb Manual 16 pages 38.99 Kb